進行汽車維修的時候,不僅要進行汽車維修也要注意人身安全。
濟南奧迪汽車維修廠家為大家收集整理的汽車維修安全注意事項，來看看吧。
When carrying out car maintenance, we should not only carry out car maintenance but also pay attention to personal safety. Jinan Audi Automobile Maintenance Factory collects and sorts out the safety precautions for automobile maintenance for everyone. Let's have a look.
(1)維修手冊規定的安全注意事項和操作規程，要求維修人員都要熟知并嚴格遵守。
(1) The maintenance personnel shall be familiar with and strictly abide by the safety precautions and operating procedures specified in the maintenance manual.
(2)當進行車輛檢修時，要拔下點火鑰匙,防止他人啟動車輛。
(2) During vehicle maintenance, remove the ignition key to prevent others from starting the vehicle.
(3)檢修電噴發動機的燃油系統時,必須先對油路進行泄壓處理,以防汽油泄漏飛濺到漏電的高壓線或高溫物體上,引起燃燒。檢修安全氣囊時必須斷開蓄電池負極線.拆裝安全氣囊時必須輕拿輕放。對車身進行電焊作業時,應當斷開蓄電池負極,以防損壞車用計算機。
(3) When overhauling the fuel system of the EFI engine, the pressure relief treatment must be carried out for the oil circuit first to prevent the gasoline leakage from splashing onto the leakage high-voltage line or high temperature object and causing combustion. Disconnect the negative battery cable when servicing the airbag Handle the airbag with care when disassembling it. When welding the vehicle body, disconnect the negative pole of the battery to prevent damage to the vehicle computer.
(4)維修運轉狀態的發動機時,應注意防止風扇葉片打傷或高溫件燙傷人體。發動機水溫很高時,不能用手直接打開散熱器蓋,以防有壓力的高溫液體燙傷人員。
(4) When repairing the running engine, pay attention to prevent the fan blade from hurting or the hot parts from scalding the human body. When the engine water temperature is very high, the radiator cap cannot be opened directly by hand to prevent personnel from being scalded by pressurized high-temperature liquid.
(5)發動機啟動前應檢查機油、冷卻液是符合要求;變速桿是否在空檔位置;拉緊手制動。在室內啟動應打開門窗,使空氣暢通。啟動后，應立即切斷油路或氣路，以免發生“飛車'事故。試驗發動機時,不得在車下作業。
(5) Before starting the engine, check whether the engine oil and coolant meet the requirements; Whether the gear lever is in neutral position; Tighten the hand brake. When starting indoors, open the doors and windows to make the air smooth. After starting, the oil or gas circuit shall be cut off immediately to avoid "runaway" accidents. When testing the engine, it is not allowed to work under the vehicle.
(6)制動系統放氣時,應當在放氣螺栓上接上專用的儲液瓶,以防制動液飛濺損傷眼睛或飛濺到輪胎、油漆上而造成損失。制動系統維修后應進行制動系統放e氣或踩幾腳制動踏板，當制動踏板合適時.方可掛檔行駛。
(6) When the brake system deflates, a special reservoir bottle should be connected to the deflating bolt to prevent the brake fluid splashing from damaging the eyes or causing damage to the tires and paint. After the brake system is repaired, bleed the brake system or step on the brake pedal. When the brake pedal is appropriate, you can drive in gear.
(7)檢修汽車電路時,不可亂拉電線。對于經常燒斷熔絲的故障,應當查明故障原因,不可換上大容量的熔絲或用銅絲代替熔絲。
(7) Do not pull wires randomly when checking and repairing automobile circuits. For the fault of frequently burning out the fuse, the cause of the fault shall be found out. It is not allowed to replace the fuse with a large capacity fuse or replace the fuse with a copper wire.
(8)在車下工作時,須確保汽車支承可靠,不要用易碎物支撐汽車。
(8) When working under the vehicle, ensure that the vehicle supports are reliable, and do not use fragile objects to support the vehicle.
We explained the safety issues in the process of vehicle maintenance and operation from eight aspects. More issues can be found on our website http://www.nhakhoathuduc.net Leave a message for consultation!
