我們在影視劇中經?？吹竭@樣的場面，主人公看著冒煙的發動機艙，一籌莫展。這就是人們常說的汽車“開鍋”。遇到這種情況，你會怎么樣呢？估計也只是把發動機艙蓋打開，看著往外冒的煙干著急。有的人甚至以為發動機就要爆炸，丟下車逃跑。汽車“開鍋”是指由于發動機過熱導致冷卻液沸騰外溢的現象。如果駕駛時溫度表超過正常數值，指向H附近，或者發動機艙蓋里往外冒白煙，說明很有可能“開鍋”了。導致過熱的原因有很多，包括冷卻液不足、給冷卻液降溫的冷卻風扇故障、節溫器故障、冷卻液溫度傳感器故障等。如果應對不當，嚴重時會導致價格不菲的發動機出現故障。因此，及時發現并正確處置過熱，可以有效減少損失。
We often see such scenes in movies and TV plays. The protagonist looks at the smoking engine compartment and finds nothing to do. This is what people often say about automobiles. What will happen to you in this situation? It's estimated that it's just opening the hood of the engine and watching the smoke coming out in a hurry. Some even thought the engine was about to explode and left the car to run away. Auto "boiling" refers to the phenomenon of coolant boiling overflow caused by engine overheating. If the thermometer is above the normal value when driving, pointing to the vicinity of H, or white smoke coming out of the engine hatch, it is likely to "boil". There are many reasons for overheating, including insufficient coolant, cooling fan fault, thermostat fault, coolant temperature sensor fault, etc. If not handled properly, serious problems may result in failure of expensive engines. Therefore, timely detection and correct disposal of overheating can effectively reduce losses.
風扇傳動帶斷裂或冷卻風扇撥生故陣的情祝
Love wishes for fan drive belt breaking or cooling fan pulling out the old battle
發動機熄火！
Engine stall!
風扇傳動帶斷裂不但會使整個冷卻系統癱瘓，還會導致發電機停止工作。發電機停止工作時，儀表盤上的充電報警燈會亮起來，這也是判斷汽車是否過熱的依據之一。如果屬于風扇傳動帶斷裂的情況，應該熄火，等待發動機自然冷卻。
Fracture of fan drive belt will not only paralyze the whole cooling system, but also cause the generator to stop working. When the generator stops working, the charging alarm light on the dashboard will turn on, which is also one of the criteria for judging whether the car is overheated or not. If the fan belt is broken, it should be extinguished and wait for the engine to cool naturally.
如果在起動狀態下冷卻風扇停止工作（可根據風扇聲音判斷），那么過熱的原因就有可能是冷卻風扇或溫度傳感器出現故障。此時好等待拖車救援，或者打開空調，使用空調風扇降溫，就近維修。
If the cooling fan stops working in the starting state (which can be judged by the sound of the fan), the cause of overheating may be the failure of the cooling fan or temperature sensor. At this time, it is better to wait for the rescue of the trailer, or turn on the air conditioner, use the air conditioning fan to cool down, and repair nearby.
出現以下情況時，可能會再次發生過熱現象，應該等待拖車救援。
When the following situation occurs, overheating may occur again, and the rescue of the trailer should be awaited.
?、亠L扇傳動帶斷裂時。
When the fan drive belt breaks.
②冷卻風扇在發動機溫度過高的狀態下仍然不工作時。
(2) Cooling fan still does not work when engine temperature is too high.
③冷卻液泄漏，補充后仍然不斷減少時。
(3) When the leakage of coolant continues to decrease after replenishment.
冷卻風扇工作正常，風扇傳動帶投有斷翻的情祝
The cooling fan works normally and the fan drive belt is broken.
不要關閉發動機
Don't turn off the engine
如果風扇傳動帶和冷卻液循環都很正常，則不要熄火，停車等待發動機冷卻。通常，人們都容易覺得發動機熄火后才更容易冷卻，其實不然，熄火后冷卻風扇和冷卻液循環都會停止，這會使發動機變得更熱。發動機艙保險杠一側裝有兩個螺旋式風扇，一個是在發動機工作時給發動機降溫的散熱風扇，一個是打開空調時用的空調風扇。所以在汽車過熱時如果風扇傳動帶沒有斷裂，則好不要讓發動機熄火，還可同時打開空調，這樣發動機降溫速度會更快。
If the fan belt and coolant circulation are normal, do not turn off, stop and wait for the engine to cool down. Usually, people tend to think that it is easier to cool the engine after it goes out. Otherwise, the cooling fan and coolant circulation will stop after the engine goes out, which will make the engine hotter. There are two spiral fans on one side of the engine compartment bumper. One is a cooling fan for the engine when the engine is working, and the other is an air conditioning fan when the air conditioning is turned on. Therefore, if the fan belt is not broken when the car is overheated, it is better not to let the engine stall, but also to turn on the air conditioner, so that the engine cooling speed will be faster.
打開發動機艙蓋時避免燙傷
Avoid scalding when opening engine hatch
為了讓發動機更快冷卻，可以打開發動機艙蓋。此時，炙熱的水蒸氣很可能導致雙手燙傷，所以不要著急，等到合適的時機再打開發動機艙蓋。待發動機冷卻，冷卻液溫度表恢復正常后可以重新起動汽車。
In order to cool the engine faster, the engine hatch can be opened. At this point, hot water vapor is likely to cause burns on both hands, so don't worry, wait until the right time to open the engine hatch. When the engine is cooled, the coolant thermometer can be restarted to normal.
發動機完全冷卻后檢查冷卻液余量
Check coolant allowance after complete cooling of engine
如前所述，冷卻液儲液罐通過軟管與散熱器相連，很容易辨認。正常情況下，儲液罐內的冷卻液液面高度應該位于MAX和MIN刻度之間。如果冷卻液余量正常且底板沒有冷卻液濺落，表明冷卻液沒有滲漏。如果冷卻液正在滲漏，則需要等待拖車救援，就近維修（交通事故導致散熱器破裂，引發冷卻液泄漏，同樣會使發動機過熱，這種情況下也要等待拖車救援）。
As mentioned earlier, the coolant tank is connected to the radiator through a hose and can be easily identified. Normally, the coolant level in the tank should be between the MAX and MIN scales. If the coolant allowance is normal and there is no coolant splash on the bottom plate, the coolant does not leak. If the coolant is leaking, it needs to wait for the rescue of the trailer and be repaired nearby. (Traffic accidents cause the radiator to break down and cause the coolant to leak, which will also overheat the engine. In this case, it also needs to wait for the rescue of the trailer.)
冷卻液不足時應及時補充
When the coolant is insufficient, it should be replenished in time
如果冷卻液儲液罐內冷卻液不足，要打開儲液罐將冷卻液補充至MAX和MIN的刻度之間。如果冷卻液已經完全耗盡，則應打開散熱器（水箱）蓋，直接加入冷卻液。
If there is insufficient coolant in the coolant tank, open the tank and replenish the coolant between the MAX and MIN scales. If the coolant has been completely exhausted, the radiator (water tank) cover should be opened and the coolant should be added directly.
檢查發動機潤滑油
Check engine lubricants
發動機潤滑油不足，溫度升高，嚴重時會引發“開鍋”現象，導致發動機出現故障。檢查發動機潤滑油時，要先熄火，等待5min之后再拔出潤滑油標尺確認。
Insufficient lubricating oil and high temperature will cause the phenomenon of "boiling" when the engine is serious, which will lead to engine failure. When inspecting the engine lubricant, it is necessary to extinguish the engine first, and wait for 5 minutes before pulling out the lubricant gauge for confirmation.
發動機降溫后去維修中心檢修
After engine cooling, go to maintenance center for repair
如果補充冷卻液后發動機恢復正常，應該盡快去維修中心進行檢修。
If the engine returns to normal after adding coolant, it should be repaired at the maintenance center as soon as possible.
More information about Jinan Mercedes-Benz automobile maintenance can be consulted by clicking on our official website: http://www.nhakhoathuduc.net/
